HasLab Modifications

Spent my morning finishing up my no cutting HasLab inner cyclotron light mod. Of course I had to cut the wires you make for the mod, but not any of the originals.

I’m still able to use D-Cell batteries but I did add the ability to use this instead. I haven’t had to recharge that during all my tinkering. https://a.co/d/8SGi2CF

I’m only using either the original D cells or this battery. Not together. One or the other. Works the same with either as far as I can tell. I thought a talentcell was overkill.

Parts list:

(more…)

3D Printable Ghost Trap is now in the shop!

Newly added set of 3D printable files to print and assemble a correct scale Ghost Trap with removable cartridge!

Get yours here

My printable designs

You can find several of my original designs on my Thingiverse page here and on the Q Pack GitHub located HERE. One worth checking out is the Ghostbusters Proton Wand pop-mech with twist. Downloadable parts and instructions allow for it to be built entirely 3d printed, or with an internal PVC support tube, or using screen accurate aluminum tubes.